Phoenix Bluetooth seriële poortadapter Manual descargar pdf (Pagina 31)

BLUETOOTH AT COMMAND LIST

7749_de_00 PHOENIX CONTACT 31

Read_Serial_Interface_Type (AT*AMSIT?)

Write_Serial_Interface_Type (AT*AMSIT=)

Read_Allow_Configuration_Over_Bluetooth (AT*ACCB?)

AT Command Description

AT*AMSIT?<CR> This command reads the serial interface type currently used.

Responses Description

<CR><LF>*AMSIT:<serial_interface_type>

Successful response

<CR><LF>ERROR<CR><LF> Error message.

Response Parameters Type Value

serial_interface_type enumerator 1: RS232 (default value)

2: RS422

3: RS485

4-255: Reserved for future use.

AT Command Description

AT*AMSIT=<serial_interface_type>,

<store_in_startup_database><CR>

This command writes the serial interface type currently used.

Note that the Serial Port Adapter does not change serial in-

terface type until the next time it is restarted.

Command Parameters Type Value

serial_interface_type enumerator See Read_Serial_Interface_Type.

store_in_startup_database enumerator 0: The setting will only be valid for the current power cycle.

1: The Serial Port Adapter will remember the setting between power cycles. The

settings database in the Serial Port Adapter will be updated.

Responses Description

<CR><LF>OK<CR><LF> Successful response

<CR><LF>ERROR<CR><LF> Error message.

AT Command Description

AT*ACCB?<CR> Determine whether or not configuration over Bluetooth is al-

lowed. Configuration can either be performed using AT com-

mands or using the ECI protocol.

Responses Description

Successful response

<CR><LF>ERROR<CR><LF> Error message.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 42 43

Sin comentarios

Phoenix Bluetooth seriële poortadapter Manual Pagina 31