Phoenix Modular switch head station 10/100Mbps Manual de usuario descargar pdf (Pagina 87)

Configuration and Diagnostics

6874_en_09 PHOENIX CONTACT 4-15

– Dynamic Host Configuration Protocol (DHCP)

Once DHCP has been enabled, the switch attempts to apply network parameters from

a DHCP server. The setting, regardless of whether DHCP is enabled or not, is saved

permanently.

– Discovery and Configuration Protocol (DCP)

Mode for assigning IP addresses in PROFINET. After startup, the switch waits for the

startup of the IO controller or an engineering tool. This status is indicated by display

output "dP". The switch can only be accessed after configuration using the assigned

IP address. The assigned IP address is not saved permanently, which means that the

switch waits to be assigned an address every time the device starts. DCP is activated

automatically if "Profinet" mode is selected.

"System Identification" Menu

This menu is used to display or modify user-specific device data, e.g., location, device

name or function. This device data is also available in SNMP.

Figure 4-16 "System Identification" menu

Once DHCP has been enabled, the display contains "01" and waits for IP parameters

from a DHCP server. As long as no IP parameters have been assigned by a DHCP

server, the switch can still be accessed via the previously set IP parameters.

If the MMS has established a PROFINET connection, a dot appears in the bottom-right

corner of the display.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 265 266

Sin comentarios

Phoenix Modular switch head station 10/100Mbps Manual de usuario Pagina 87